Command: show mld_snooping mrouter_ports all
VLAN Name : default
Static Router Port : 1:1-1:10
Dynamic Router Port :
Router IP : FE08::1
Forbidden Router Port : 1:11
Total Entries: 1
63-11 create mld_snooping static_group
Description
This command is used to create an MLD snooping static group. Member ports can be added to the
static group. The static member and the dynamic member ports form the member ports of a group.
The static group will only take effect when MLD snooping is enabled on the VLAN. For those static
member ports, the device needs to emulate the MLD protocol operation to the querier, and forward
the traffic destined to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packets destined for this specific
group to static member ports.
The static member ports will only affect MLD V1 operation.
The Reserved IP multicast addresses FF0x::/16 must be excluded from the configured group.
The VLAN must be created first before a static group can be created.
Format
create mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
Parameters
vlanid - Specify the ID of the VLAN on which the static group resides.
<vlanid_list> - Enter the VLAN ID list here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an MLD snooping static group for VLAN, named default; group FF1E::1: