D-Link xStack DGS-3120 Series - Page 665

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
660
DGS-3120-24TC:admin# create mcast_filter_profile profile_id 2 profile_name MOD
Command: create mcast_filter_profile profile_id 2 profile_name MOD
Success.
DGS-3120-24TC:admin#
65-2 config mcast_filter_profile
Description
This command is used to add or delete a range of multicast IP addresses to or from the profile.
Format
config mcast_filter_profile [profile_id <value 1-24> | profile_name <name 32>] {profile_name
<name 32> | [add | delete] <mcast_address_list>}(1)
Parameters
profile_id - ID of the profile.
<value 1-24> - Enter the profile ID value . This value must be between 1 and 24.
profile_name - Provides a meaningful description for the profile.
<name 32> - Enter the profile name . The profile name can be up to 32 characters long.
profile_name - Provides a meaningful description for the profile.
<name 32> - Enter the profile name . The profile name can be up to 32 characters long.
add - Specify to add a multicast address.
delete - Specify to delete a multicast address.
<mcast_address_list> - List of the multicast addresses to be put in the profile. You can either
specify a single multicast IP address or a range of multicast addresses using “-”.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add the multicast address range 225.1.1.1 to 225.1.1.10 to the profile:
DGS-3120-24TC:admin# config mcast_filter_profile profile_id 2 add 225.1.1.1 -
225.1.1.10
Command: config mcast_filter_profile profile_id 2 add 225.1.1.1 - 225.1.1.10
Success.
DGS-3120-24TC:admin#
65-3 config mcast_filter_profile ipv6
Description
This command is used to add or delete a range of IPv6 multicast addresses to the profile.