D-Link xStack DGS-3120 Series - Page 670

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
665
replace - The new group will replace the eldest group in the register table.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the maximum number of multicast group that ports 1:1 and 1:3 can join to 100:
DGS-3120-24TC:admin#config max_mcast_group ports 1:1,1:3 max_group 100
Command: config max_mcast_group ports 1:1,1:3 max_group 100
Success.
DGS-3120-24TC:admin#
65-8 show max_mcast_group
Description
This command is used to display the maximum number of multicast groups that a port can join. If
the IPv4 or IPv6 option is not specified, IPv4 is implied.
Format
show max_mcast_group [ports {<portlist>} | vlanid {<vlanid_list >}] {[ipv4 | ipv6]}
Parameters
ports - Specify the range of ports for displaying information about the maximum number of
multicast groups that the specified ports can join.
<portlist> - (Optional) Enter the list of ports to be configured here.
vlanid - Specify the VLAN ID for displaying the maximum number of multicast groups.
<vlanid_list> - (Optional) Enter the VLAN ID list here.
ipv4 - (Optional) Specify to display the maximum number of IPv4 learned addresses.
ipv6 - (Optional) Specify to display the maximum number of IPv6 learned addresses.
Restrictions
None.
Example
To display the maximum number of multicast groups that ports 1 and 2 can join: