D-Link xStack DGS-3120 Series - Page 679

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
674
<vlanid 1-4094> - Enter the customer VLAN ID.
null - Specify to not have the customer VLAN ID carrying in MLD query.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an MLD snooping multicast VLAN with the name “v1”, make ports 1 and 3 members
of the VLAN, and set the state to enable:
DGS-3120-24TC:admin#config mld_snooping multicast_vlan v1 add member_port
1:1,1:3 state enable
Command: config mld_snooping multicast_vlan v1 add member_port 1:1,1:3 state
enable
Success.
DGS-3120-24TC:admin#
66-4 create [igmp_snooping | mld_snooping]
multicast_vlan_group_profile
Description
This command is used to create an IGMP or MLD snooping multicast group profile on the Switch.
Format
create [igmp_snooping | mld_snooping] multicast_vlan_group_profile <profile_name 1-32>
Parameters
igmp_snooping - Specify that an IGMP snooping profile will be created.
mld_snooping - Specify that an MLD snooping profile will be created.
multicast_vlan_group_profile - Specify the multicast VLAN profile name. The maximum length
is 32 characters.
<profile_name 1-32> - Enter the multicast VLAN group profile name here. The name can be
up to 32 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IGMP snooping multicast group profile with the name “test”: