D-Link xStack DGS-3120 Series - Page 717

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
712
Restrictions
None.
Example
To display OSPF areas configuration:
DGS-3120-24TC:admin#show ospf area
Command: show ospf area
OSPF Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost Translate
--------------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None None None
10.48.74.122 Stub Enabled 1 None
Total Entries : 2
DGS-3120-24TC:admin#
70-10 create ospf host_route
Description
This command is used to create an OSPF host route.
Format
create ospf host_route <ipaddr> {area <area_id> | metric <value 1-65535>}
Parameters
<ipaddr> - Enter the host’s IP address used here.
area - (Optional) Specify a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
<area_id> - Enter the area ID value here.
metric - (Optional) Specify a metric that will be advertised.
<value 1-65535> - Enter the metric value used here. This value must be between 1 and
65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an OSPF host route: