D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
715
DGS-3120-24TC:admin#show ospf host_route
Command: show ospf host_route
OSPF Host Route Settings
Host Address Metric Area ID
--------------- ------ ---------------
10.48.74.122 3 10.1.1.1
Total Entries : 1
DGS-3120-24TC:admin#
70-14 config ospf router_id
Description
The command is used to configure the router ID for the Switch. Each Switch that is configured to
run OSPF must have a unique router ID.
Format
config ospf router_id <ipaddr>
Parameters
<ipaddr> - Enter the router's IP address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the router ID for the Switch:
DGS-3120-24TC:admin#config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
DGS-3120-24TC:admin#
70-15 create ospf virtual_link
Description
This command is used to create an OSPF virtual link.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)