D-Link xStack DGS-3120 Series - Page 734

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
729
Restrictions
None.
Example
To display OSPFv3 configurations:
DGS-3120-24TC:admin#show ospfv3
Command: show ospfv3
OSPFv3 Router ID : 1.1.1.1
State : Disabled
OSPFv3 Interface Settings
Interface Area ID State Link Metric Instance ID
Status
------------ --------------- -------- --------- --------- -----------
Total Entries: 0
OSPFv3 Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost
--------------- ------ ----------------------- -----------------
0.0.0.0 Normal None None
Total Entries: 1
Virtual Interface Configuration
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
71-6 create ospfv3 area
Description
This command is used to create an OSPFv3 area.
Format
create ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
Parameters
<area_id> - Enter the OSPFv3 area ID. It is a 32-bit number in the form of an IPv4 address that
uniquely identifies the OSPFv3 area in the OSPFv3 domain.
type - The OSPFv3 area mode of operation.
normal - Define the OSPFv3 area created as a normal area.
stub - Define the OSPFv3 area created as a stub area.