xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
755
DGS-3120-24TC:admin# ping 10.51.17.1 times 4
Command: ping 10.51.17.1 times 4
Reply from 10.51.17.1, time<10ms
Reply from 10.51.17.1, time<10ms
Reply from 10.51.17.1, time<10ms
Reply from 10.51.17.1, time<10ms
Ping Statistics for 10.51.17.1
Packets: Sent =4, Received =4, Lost =0
74-2 ping6
Description
This command is used to send IPv6 Internet Control Message Protocol (ICMP) echo messages to
a remote IPv6 address. The remote IPv6 address will then “echo” or return the message. This is
used to confirm the IPv6 connectivity between the Switch and the remote device.
Format
ping6 [<ipv6addr> | <domain_name 255>] {times <value 1-255> | size <value 1-6000> |
timeout <sec 1-99> | source_ip <ipv6addr>}
Parameters
<ipv6addr> - Enter the IPv6 address here.
<domain_name 255> - Enter the domain name of the host.
times - (Optional) The number of individual ICMP echo messages to be sent. A value of 0 will
send an infinite ICMP echo messages. The maximum value is 255. The default is 0, indicating
infinity. Press the "CTRL+C” to break the ping test.
<value 1-255> - Enter the number of individual ICMP echo messages to be sent here. This
value must be between 1 and 255.
size - (Optional) Size of the test packet.
<value 1-6000> - Enter the size of the test packet here. This value must be between 1 and
timeout - (Optional) Defines the time-out period while waiting for a response from the remote
device.
<sec 1-99> - Enter the time-out period here. This value must be between 1 and 99 seconds.
source_ip - (Optional) Specify the source IP.
<ipv6addr> - Enter the IPv6 address.
Restrictions
None.
Example
To send ICMP echo message to “3000::1” for 4 times:
To Next Page
Loading...
Need help?
General
