D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
777
Format
config power_saving port [<portlist> | all] [[add | delete] time_range <range_name 32> |
clear_time_range]
Parameters
<portlist> - Specify a range of ports.
all - Specify all ports.
add - Specify to add a time range.
delete - Specify to delete a time range.
time_range - Specify the name of the time range.
<range_name32> - Enter a name for maximum 32 characters.
clear_time_range - Specify to clear all the time range of port.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To add a time range named “range_1” on port 1:
DGS-3120-24TC:admin#config power_saving port 1:1 add time_range range_1
Command: config power_saving port 1:1 add time_range range_1
Success.
DGS-3120-24TC:admin#
To delete a time range named “range_2” on port 1:
DGS-3120-24TC:admin#config power_saving port 1:1 delete time_range range_2
Command: config power_saving port 1:1 delete time_range range_2
Success.
DGS-3120-24TC:admin#
78-5 show power_saving
Description
This command is used to display the current state of power saving.
Format
show power_saving {length_detection | link_detection | led | port | hibernation}

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)