D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
782
Parameters
None.
Restrictions
None.
Example
To display PPPoE circuit ID insertion status:
DGS-3120-24TC:admin#show pppoe circuit_id_insertion
Command: show pppoe circuit_id_insertion
Global PPPoE State: Enabled
DGS-3120-24TC:admin#
79-4 show pppoe circuit_id_insertion ports
Description
This command is used to display Switch’s port PPPoE Circuit ID insertion configuration.
Format
show pppoe circuit_id_insertion ports {<portlist>}
Parameters
<portlist> - (Optional) Specify a list of ports to be displayed.
Restrictions
None.
Example
To display port 2-5 PPPoE circuit ID insertion configuration:
DGS-3120-24TC:admin#show pppoe circuit_id_insertion ports 1:2-1:5
Command: show pppoe circuit_id_insertion ports 1:2-1:5
Port State Circuit ID
---- -------- ---------------------------------------------
1:2 Enabled Switch IP
1:3 Enabled Switch IP
1:4 Enabled Switch IP
1:5 Enabled Switch IP

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)