D-Link xStack DGS-3120 Series - Page 796

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
791
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the candidate rendezvous point (RP) holdtime, priority and wildcard prefix count:
DGS-3120-24TC:admin#config pim crp holdtime 150 priority 192
wildcard_prefix_cnt 0
Command: config pim crp holdtime 150 priority 192 wildcard_prefix_cnt 0
Success.
DGS-3120-24TC:admin#
80-9 create pim crp group
Description
This command is used to add a multicast group range into a C-RP serve list for PIM-SM.
Format
create pim crp group <network_address> rp <ipif_name 12>
Parameters
group - Specify the multicast group address for this Switch to become a Candidate RP. This
address must be a class D address.
<network_address> - Enter the group network address used here.
rp - Specify that the interface will act as C-RP for the group.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a multicast group range into a C-RP server list:
DGS-3120-24TC:admin#create pim crp group 224.1.2.3/32 rp System
Command: create pim crp group 224.1.2.3/32 rp System
Success.
DGS-3120-24TC:admin#