D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
793
DGS-3120-24TC:admin#show pim crp
Command: show pim crp
PIM Candidate-RP Table
C-RP Holdtime : 150
C-RP Priority : 192
C-RP Wildcard Prefix Count : 0
Group Interface
------------------ ------------------
224.1.2.3/32 System
Total Entries: 1
DGS-3120-24TC:admin#
80-12 config pim last_hop_spt_switchover
Description
This command is used by the last hop router to decide whether to receive the multicast data from
the shared tree or switch over to the shortest path tree. When the switchover mode is set to be
never, the last hop router will always receive the multicast data from the shared tree. When the
mode is set to immediately, the last hop router will always receive the multicast data from the
shortest path tree.
Format
config pim last_hop_spt_switchover [never | immediately]
Parameters
never - Specify that the router will always receive multicast data from the shared tree.
immediately - Specify that the router will always receive multicast data from shortest path tree.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
Set the SPT-switchover mode to never:
DGS-3120-24TC:admin#config pim last_hop_spt_switchover never
Command: config pim last_hop_spt_switchover never
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)