D-Link xStack DGS-3120 Series - Page 80

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
75
5-18 create authen server_group
Description
This command is used to create a user-defined authentication server group. The maximum
supported number of server groups including built-in server groups is 8. Each group consists of 8
server hosts as maximum.
Format
create authen server_group <string 15>
Parameters
<string 15> - The user-defined server group name. This value can be up to 15 characters long.
Restrictions
Only Administrator-level users can issue this command.
Example
To create a user-defined authentication server group:
DGS-3120-24TC:admin# create authen server_group mix_1
Command: create authen server_group mix_1
Success.
DGS-3120-24TC:admin#
5-19 config authen server_group
Description
This command is used to add or remove an authentication server host to or from the specified
server group. Built-in server group “tacacs”, “xtacacs”, “tacacs+”, “radius” accepts the server host
with the same protocol only, but user-defined server group can accept server hosts with different
protocols.
Format
config authen server_group [tacacs | xtacacs | tacacs+ | radius | <string 15>] [add | delete]
server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
Parameters
server_group - User-defined server group.
tacacs - Built-in server group “tacacs”.
xtacacs - Built-in server group “xtacacs”.
tacacs+ - Built-in server group “tacacs+”.
radius - Built-in server group “radius”.
<string 15> - Enter the server group name here. This value can be up to 15 characters long.