D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
795
80-14 create pim static_rp group
Description
This command is used to create a static RP.
Format
create pim static_rp group <network_address> rp <ipaddr>
Parameters
group - Specify to assign the multicast group address for this static RP.
<network_address> - Enter the multicast group address used here.
rp - Specify the IP address used by this static RP.
<ipaddr> - Enter the IP address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a static RP:
DGS-3120-24TC:admin#create pim static_rp group 239.1.1.0/24 rp 10.52.33.18
Command: create pim static_rp group 239.1.1.0/24 rp 10.52.33.18
Success.
DGS-3120-24TC:admin#
80-15 delete pim static_rp group
Description
This command is used to delete a static RP.
Format
delete pim static_rp group <network_address>
Parameters
<network_address> - Enter Specify the multicast group address that will removed from the static
RP.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)