D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
842
Example
To show scheduling mechanism:
DGS-3120-24TC:admin#show scheduling_mechanism
Command: show scheduling_mechanism
Port Mode
----- ------
1:1 Strict
1:2 Strict
1:3 Strict
1:4 Strict
1:5 Strict
1:6 Strict
1:7 Strict
1:8 Strict
1:9 Strict
1:10 Strict
1:11 Strict
1:12 Strict
1:13 Strict
1:14 Strict
1:15 Strict
1:16 Strict
1:17 Strict
1:18 Strict
1:19 Strict
1:20 Strict
1:21 Strict
1:22 Strict
1:23 Strict
1:24 Strict
DGS-3120-24TC:admin#
84-9 config 802.1p user_priority
Description
This command is used to map the 802.1p user priority of an incoming packet to one of the eight
hardware queues available on the Switch.
Format
config 802.1p user_priority <priority 0-7> <class_id 0-7>
Parameters
<priority 0-7> - The 802.1p user priority you want to associate with the <class_id> (the number
of the hardware queue) with.
<class_id 0-7> - The number of the Switch’s hardware priority queue. The switch has 8 hardware

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)