D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
864
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the RIP timers:
DGS-3120-24TC:admin#config rip timers update 60 timeout 360 garbage_collection
240
Command: config rip timers update 60 timeout 360 garbage_collection 240
Success.
DGS-3120-24TC:admin#
87-5 show rip
Description
This command is used to display the RIP configuration for one or all IP interfaces.
Format
show rip {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the system will display RIP configuration and statistics for all the IP
interfaces.
Restrictions
None.
Example
To display RIP configuration and statistics for all IP interfaces.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)