D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
943
Example
Configure the sFlow sampler the rate of port 1 to be 0:
DGS-3120-24TC:admin#config sflow flow_sampler ports 1:1 rate 0 maxheadersize 18
Command: config sflow flow_sampler ports 1:1 rate 0 maxheadersize 18
Success.
DGS-3120-24TC:admin#
98-3 delete sflow flow_sampler
Description
This command is used to delete the sFlow flow sampler.
Format
delete sflow flow_sampler ports [<portlist> | all]
Parameters
ports - Specify the list of ports to be configured.
<portlist> - Enter the list of ports that will be used for this configuration here.
all - Specify all ports on the Switch.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Delete the sFlow sampler port 1:
DGS-3120-24TC:admin#delete sflow flow_sampler ports 1:1
Command: delete sflow flow_sampler ports 1:1
Success.
DGS-3120-24TC:admin#
98-4 create sflow counter_poller
Description
This command is used to create the sFlow counter poller. The poller function instructs the Switch
to forward statistics counter information with respect to a port.
Format
create sflow counter_poller ports [<portlist> | all] analyzer_server_id <value 1-4> {interval
[disable | <sec 20-120>]}

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)