D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
945
Example
Configure the interval of sFlow counter poller port 1 to be 0:
DGS-3120-24TC:admin#config sflow counter_poller ports 1:1 interval disable
Command: config sflow counter_poller ports 1:1 interval disable
Success.
DGS-3120-24TC:admin#
98-6 delete sflow counter_poller
Description
This command is used to delete the sFlow counter poller from the specified port.
Format
delete sflow counter_poller ports [<portlist> | all]
Parameters
ports - Specify the list of ports to delete the counter poller.
<portlist> - Enter the list of ports that will be used for this configuration here.
all - Specify all ports on the Switch.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Delete sFlow counter poller on port 1:
DGS-3120-24TC:admin#delete sflow counter_poller ports 1:1
Command: delete sflow counter_poller ports 1:1
Success.
DGS-3120-24TC:admin#
98-7 create sflow analyzer_server
Description
This command is used to create the analyzer server. You can specify more than one
analyzer_server with the same IP address but with different UDP port numbers. You can have up
to four unique combinations of IP address and UDP port number.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)