D-Link xStack DGS-3120 Series - Page 989

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
984
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable the sending of linkchange traps:
DGS-3120-24TC:admin# disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-3120-24TC:admin#
101-32 config snmp linkchange_traps ports
Description
This command is used to configure the sending of linkchange traps and per port control for
sending of change trap.
Format
config snmp linkchange_traps ports [all | <portlist>] [enable | disable]
Parameters
all - To specify all ports.
<portlist> - To specify a port range.
enable - Enable sending of the link change trap for this port.
disable - Disable sending of the link change trap for this port.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the sending of linkchange traps:
DGS-3120-24TC:admin# config snmp linkchange_traps ports 1:1-1:4 enable
Command: config snmp linkchange_traps ports 1:1-1:4 enable
Success.
DGS-3120-24TC:admin#