D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
994
DGS-3120-24TC:admin# show sim neighbor
Command: show sim neighbor
Neighbor Table
Port MAC Address Role
------ ------------------ ---------
23 00-35-26-00-11-99 Commander
23 00-35-26-00-11-91 Member
24 00-35-26-00-11-90 Candidate
Total Entries: 3
DGS-3120-24TC:admin#
102-4 reconfig
Description
This command is used to re-telnet to member.
Format
reconfig [member_id <value 1-32> | exit]
Parameters
member_id - Specify the serial number of the member.
<value 1-32> - Enter the serial number of the member here.
exit - Specify to exit from the telnet session.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To re-telnet to member:
DGS-3120-24TC:admin# reconfig member_id 1
Command: reconfig member_id 1
DGS-3120-24TC:admin#
Login:
102-5 config sim_group
Description
This command is used to configure group information.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)