GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
3-98 Section 3-4 - Preparing for Installation
PRELIMINARY
4.) Click on Properties.
The Worklist Properties dialog box opens:
5.) Select the appropriate settings to configure the Worklist (IP address, etc), as required.
6.) When done, click OK to close the dialog box.
7.) Under Selected devices > Outputs (refer to Figure 3-111), select Dicom storage.
8.) Click on Properties.
The Dicom Storage Properties dialog box opens:
Figure 3-112 Worklist Properties Dialog Box
Figure 3-113 DICOM Storage Properties Dialog Box
To Next Page
Loading...
