GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-121
PRELIMINARY
The selected flow is shown, as seen in the example in Figure 3-141 below (Worklist/Local Archive
- DICOM Server/Int. HD).
6.) Select Worklist (so it is highlighted) and then select Properties to display the Properties dialog.
7.) Select the IP-Address down-arrow to choose the Worklist Server from the pull-down menu.
NOTE: It is not possible to change the setting in the IP-Address field by editing it. See description
below, starting with step 8, to change the setting.
Figure 3-141 Worklist/Local Archive - DICOM Server/Int. HD Flow
Figure 3-142 Select Worklist Properties Dialog Box
Select Worklist
and then select
Properties
Worklist Properties Dialog
To Next Page
Loading...
