GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-159
PRELIMINARY
12.)Detach the RFI Board from the TR32 Boards (separate by gently pulling them apart), as shown in
Figure 8-196 below.
13) Separate the two TR32 Boards from each other, as shown in Figure 8-197 below
14.)Separate each of the two TR32 Boards from their respective Heat Sink pads - see Figure 8-198.
NOTE: Proceed to replace the defective board, as described in the appropriate steps of the following
procedure.
Figure 8-196 Removing the RFI Board from the TR32 Boards
Figure 8-197 Separating the Two TR32 Boards from Each Other
Figure 8-198 Heat Sink Pad Separated from TR32 Board
TR32 Board
TR32 Board
RFI Board
To Next Page
Loading...
