GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-194 Section 8-7 - Mechanical Components Replacement Procedures
PRELIMINARY
8-7-3 Lower Arm Replacement Procedure (cont’d)
4.) While moving the keyboard slightly up and down with one hand, use the screwdriver to push the
securing pin all the way out of the base of the operator panel, as shown in Figure 8-243 below.,
5) Using one hand to tilt the console backwards, use the other hand to support the lower arm as it tilts
downwards, as shown in Figure 8-244 below.
Figure 8-243 Removing Securing Pin from Base of Operator Panel
Figure 8-244 Releasing the Lower Arm from the Fixed Position
To Next Page
Loading...
