GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-197
PRELIMINARY
5) Lower the console and raise the Lower Arm to insert the upper support pin previously removed
- Figure 8-248.
6.) While moving the console slightly up and down with one hand, insert the securing pin (previously
removed) - refer to Figure 8-243 on page 8-194.
7.) Return and fasten the screw (previously removed from the base of the operator panel - below the
keyboard, as shown in Figure 8-242 on page 8-193).
8) Make sure that the console is aligned in the central position (not pulled to one side or the other).
9) Lower the console to the maximum down position.
10.)Turn ON power to the system.
11.)Proceed to perform the following functionality tests:
- “Arm Movement Test” on page 4-35
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
Figure 8-248 Raising Lower Arm to Reconnect with Upper Arm (Console not shown)
To Next Page
Loading...
