genesys ensemble/genesys grand ensemble
Page 16
Since this function can be used to either increase or decrease
the filter cut-off point of the original sound, the original cut-off
point of the sound can be restored by setting the value to zero.
RESONANCE
This function, the second essential element of filter control,
introduces complex harmonic overtones which are added
to the final sound. Sometimes these overtones can only be
produced when the Filter Cut-Off setting is low enough.
Try setting the Resonance value fairly high and then varying
the Cut-Off value while you play. The distinctive sound of a
resonating filter is one of the key elements in many classic
synthesizer sounds.
Since this function can be used to either increase or decrease
the amount of resonance in the original sound, the original
amount of resonance can be restored by setting the value
to zero.
LFO DEPTH
This control is used to set the amount of vibrato or
modulation applied to a sound. If the current sound includes
some type of modulation or vibrato, you can use this function
to either increase, decrease or completely remove the effect,
(by setting the function to minimum).
Since this function can be used to either increase or decrease
the LFO depth in the original sound, the original LFO depth
can be restored by setting the value to zero.
LFO RATE
This function can be used to adjust the speed of the vibrato
or modulation in a sound. It is designed to be used in
conjunction with the LFO DEPTH function.
Since this function can be used to either increase or decrease
the LFO rate in the original sound, the original LFO rate can
be restored by setting the value to zero.
To Next Page
Loading...
Need help?
General
