genesys ensemble/genesys grand ensemble
Page 82
There are two different ways to adjust the velocity of the
selected notes
TRANSPOSE
This function is used to
transpose the pitch of the
notes recorded in the se-
lected track.
First select the track you want
to change by pressing its
track select button. You
should see the name of the
selected track in the top right
side of the display.
Next, specify which part of the track you want to change, (from
measure X to measure Y), by setting FROM LOC and TO LOC. You
can also NOTE RANGE FROM / TO to set a specific range of notes
to be edited. Notes which fall outside the specified range will not
be affected by the operation.
Now set the TRANSPOSE value to the number of half steps you
want the selected notes to be shifted by. You can also transpose
down by setting negative values.
Press ENTER to complete the operation.
NOTE: You can also transpose a track by using the TRANSPOSE func-
tion in SECTION EDIT / PRESET / EDIT PARTS. This is a more flexible
function because it allows you to continually change the transpose
settings while you are listening to the song playback. However, this
function only changes the pitch of the related sound and does not
modify the data recorded into the track. This function should be used
only if you intend to replay your song on the Genesys.
NORMAL: When this is set, use the CHANGE VELOCITY parameter
to select how much you want to increase or decrease the current
velocity values by. To set a decrease simply choose a negative value.
FIXED: Choosing this setting will automatically convert all veloc-
ity values in the selected track to the value of CHANGE VELOCITY.
Press ENTER to execute the operation.
To Next Page
Loading...
Need help?
General
