J
Copying a single track to another track
First select the track you want to copy by pressing its track
select button on the left. You should see the name of the
selected track in the top right side of the display.
Next, specify which part of the track you want to copy, (from
measure X to measure Y), with FROM LOC and TO LOC. You
may also use NOTE RANGE FROM / TO to set a specific range
of notes to be copied. Notes which fall outside the specified
range will not be copied.
Now make the following selections:
Copy Mode
REPLACE mode will erase whatever was in the target portion
of the destination track to make way for the new data. MERGE
mode will simply combine the new data with whatever was in
the destination track before.
To Track
Select the destination track
To Song
You can copy the selected track or partial track to a different
song if you wish. Do not adjust this if you want to copy the
track within the current song.
Copy Times: Set this to 1 for a single copy of the data. Setting
values higher than 1 will create repeat-copies of the data.
Press ENTER to execute the operation.
To Next Page
Loading...
Need help?
General
