Hioki IM3570 - Page 161

5.3 Normal Sweep
153
5
Chapter 5 ANALYZER Function
When you want to cancel the setting:
Press .
Sets the start value of the sweep and the step
width of sweep points.
Each sweep point is automatically calculated
from the number of sweep points.
開始値
ステップ
幅
Start value
Step Width
Sets the start value and end value of the sweep.
Each sweep point is automatically calculated
from the number of sweep points.
開始値 終了値
掃引点数
Start value End value
Number of sweep points
Sets the center value of the sweep range and
the sweep width.
Each sweep point is automatically calculated
from the number of sweep points.
中心値
掃引幅
Center value
Sweep Width
Fixes the sweep parameter and performs mea-
surement at a set time interval.
タイムインターバル
掃引点数
Time
Time interval
Number of sweep points
Select the setting method of the sweep range.
For details on the settings, refer to the following figures.
3
START-STOP Settings