Hioki IM3570 - Spot Compensation

7.1 Setting Open Circuit Compensation
277
7
Chapter 7 Error Compensation
Acquire the compensation values at the set measurement frequencies. Measurement frequencies can be set
for up to five points.
7.1.2 Spot Compensation
Procedure
1
Press to confirm the frequency for compensation.
Select in the open circuit compensa-
tion screen, and press to confirm the
selection.
Use or to select the compensation
point you want to set or edit, and press
.
3
4
Open Compensation Setting
Spot Compensation Value Setting
2
Spot Compensation
Until one of these keys is pressed for input of a numer-
ical value, the previous frequency for which SPOT
compensation was performed is displayed.
• Settable range: DC, 4 Hz to 5.000 MHz
If a value in excess of 5 MHz is entered, the mea-
surement frequency will automatically set to 5
MHz.
• If a value less than 4 Hz is entered, the measure-
ment frequency will automatically set to 4 Hz.
• If you make a mistake during input:
press to cancel the input and start again.
Use the numeric keypad to enter a frequency
for compensation.
When you do not want to perform compen-
sation: Press .
Compensation is not performed and the compensa-
tion screen is redisplayed.