Hioki IM3570 - Chapter 8 Setting the SYSTEM; 8.1 Setting the Interface

7.3 Compensating Values to Match Reference Values (Load Compensation)
297
7
Chapter 7 Error Compensation
Setting of Parameter to Use for Reference Value
Parameter Setting
See "1.3.7 Parameter Settings Screen" (p. 25)
2. Select the parameter mode of the reference value to be
set.
3. Press to close the setting screen.
Parameter Setting
1. Press .
• If the compensation frequency, compensation range, and compensation level are not set, the
parameter to use for the reference value setting cannot be set.
• When DC is selected for the compensation frequency setting, Rdc is selected automatically
and the parameter to use for the reference value setting cannot be set.
• If you change the parameter to use as the reference value, the settings of reference value 1
and reference value 2 are cleared.