Hioki IM3570 - Setting Basic Settings of Measurement Conditions; Setting the Measurement Frequency

4.2 Setting Basic Settings of Measurement Conditions
41
4
Chapter 4 LCR Function
Set the frequency of the signal to apply to the test sample. For some test samples, the value may vary
depending on the measurement frequency.
4.2 Setting Basic Settings of
Measurement Conditions
LCR
ANALYZER
4.2.1 Setting the Measurement frequency
1
3
LCR Initial Screen
Example: Measurement frequency: 1 kHz
LCR Basic Settings
Procedure
Set each digit.
Set the frequency with the numeric keypad.
Frequency Setting (Digits) Frequency Setting (Numeric Keypad)
2
Press .
There are the following two frequency input
methods.
Press or to change the input
method.
LCR Basic Settings