Hioki IM3570 - 5.4 Segment Sweep

5.3 Normal Sweep
161
5
Chapter 5 ANALYZER Function
When an element other than a capacitor or a capacitor with a low DC resistance is measured
while using DC bias, the AUTO range may not work properly and a range may not be able to
be determined.
If the instrument is being used outside the lim-
its of its specification, the suitable range may
not be set in auto ranging function. In this
case, check the accuracy assured ranges in
"13.2 Measurement Range and Accuracy" (p.
395) and then change the test conditions.
Press .
4
3
Press to close the setting screen.
Range Setting