Hioki IM3570 - Page 58

4.2 Setting Basic Settings of Measurement Conditions
50
When an element other than a capacitor or a capacitor with a low DC resistance is measured
while using DC bias, the AUTO range may not work properly and a range may not be able to
be determined.
Press .
4
3
Press to close the setting screen.
If the instrument is being used outside the lim-
its of its specification, the suitable range may
not be set in auto ranging function. In this case,
check the
accuracy assured ranges in "13.2 Measure-
ment Range and Accuracy" (p. 395) and then
change the test conditions.
Range Setting