4.3 Setting DC Resistance Measurement
83
4
Chapter 4 LCR Function
The time required until the DC signal level stabilizes differs depending on the test sample to
be measured. To ensure measurement is performed accurately, observe the measurement
waveform in advance and then set the delay time required until the DC signal level stabi-
lizes.
4
Press to close the setting screen.
Use or to enter the delay time.
3
Settable range: 0.0003 to 9.9999 s
Delay Time Setting
When you want to cancel setting of the delay
time: Press .
The set time is set to 0.0003 s.
Press .
2
Rdc Basic Settings
To Next Page
Loading...
