6
CONVERTER MODE SETTING SCREEN
6-70
@2 Session Timer
Set the time to cut the TCP session when there is no communication from the
host. (Default: 30)
Setting range: 0 to 86400 seconds
* The timeout does not occur when “0” is set.
@3 DID
Select “Enable” to use the DID (Direct Inward Dialing) function.
(Default: Disable)
@4 Control Mode
Select the transceiver system connected to the VE-PG3.
(Default: NXDN Conventional)
@5 Individual Call
Select “Enable” to use the DID (Direct Inward Dialing) function.
(Default: Disable)
@6 Talkgroup Call
Enter the characters to be recognized as an IP telephone for a group call.
(Default: *2)
@7 Prefix ID
Enter the default prefix ID that is automatically added if a Prefix ID is not
specified. This is necessary only if you select the NXDN Trunking.
*The Prefix ID is not used if an invalid ID is entered.
(Default: *1)
9. [Port Settings] Menu (continued)
M Transceiver 1 (TRX1)/Transceiver 2 (TRX2)
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
*
1
Appears only when “Enable” is selected in [Power Detection].
*
2
Appears only when “Enable” is selected in [Serial Communication].
*
3
Appears only when “Manual” is selected in [Data Mode].
*
1
*
2
*
3
!2
!3
!4
!5
!6
!7
!8
!9
@0
@1
@2
@3
@3
@3
@4
@4
@4
@5
@5
@6
@6
@7
@8
@8
@9
#0
"NXDN Trunking"
"NXDN Conventional"
"dPMR"
Client Mode:Enable
#1
#2
#3
To Next Page
Loading...
