Krone Comprima CF 155 XC - Lowering the Parking Support; Disconnecting the PTO Shaft from the Tractor

Driving and Transport
100
Pos: 46.28 /BA/Fahren und Transport/Rundba llenpresse/Bild Abst ellstütze runter Compr ima @ 66\mod_130217391161 5_78.docx @ 615037 @ 3 @ 1
7.2.2 Lowering the Parking Support
1
2
3
RPN00037
Fig. 67
Pos: 46.29 /BA/Fahren und Transport/Rundba llenpresse/Abstel lstütze positionier en @ 32\mod_125361758407 8_78.docx @ 315512 @ @ 1
• Remove stake bolt (2), bring the support pipe out of the parking support (1) and then secure
again with the stake bolt (2).
• Crank the support plate (3) tightly onto the ground until pressure on the drawbar has been
relieved.
Pos: 46.30 /Übersc hriften/Überschri ften 3/F-J/Gelenkwel le vom Schlepper trennen @ 32\ mod_1253619549515_78. docx @ 315616 @ 3 @ 1
7.2.3 Disconnecting the PTO shaft from the tractor
Pos: 46.31 /BA/Er stinbetriebnahme/Rundba llenpresse/Ge lenkwelle/Bild Gelen kwelle ablegen @ 32\mod_125 3534197361_78.doc x @ 314306 @ @ 1
RBV02240
2
1
Fig. 68
Pos: 46.32 /BA/Fahren und Transport/Rundba llenpresse/Gelenkw elle abziehen @ 32\mod_12 53618661515_78.doc x @ 315541 @ @ 1
• Disconnect the PTO shaft (1) on the tractor side.
Pos: 46.33 /BA/Er stinbetriebnahme/Rundba llenpresse/Ge lenkwelle/Gelenkwel le ablegen @ 32\mod_12535 34329111_78.docx @ 314 331 @ @ 1
• Place the PTO shaft (1) inside the PTO shaft support (2).
Pos: 46.34 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1