Operation
212
Pos: 55.14 /BA/Bedienun g /Rundballenpresse/ Fahrgeschwindi gkeit @ 35\mod_1256125846 472_78.docx @ 326411 @ 22 @ 1
11.2 Travelling speed
The forward speed during use depends on the following factors:
• type of crops
• moisture content of the crops
• height of swaths
• ground conditions
Note
The recommended travelling speed is 5 - 12 km/h and must be adapted to local conditions in
actual practice.
• Do not overload the round baler.
• When baling a round bale, reduce speed at the start and end of the baling process.
Pos: 55.15 /BA/Bedienun g /Rundballenpresse/ Einstellung bei Sc hlupf des Rollbodens @ 59\ mod_1297348303356_78. docx @ 556695 @ @ 1
Setting in case of slip of the floor conveyor if the grass is very wet and only with little
structure
• Drive with less blades or turn off the blades or remove them and reduce the baling pressure
• Adjust inner bale core to soft (see Chapter entitled “Adapt Soft Core”)
Pos: 55.16 /BA/Bedienun g /Rundballenpresse/ ohne Messer fahr en XC und HD @ 119\mod_134217678711 0_78.docx @ 1079709 @ @ 1
• Driving without blades
CAUTION!
Damages to the machine
• There must be no driving with blades and lowered blade base since the blades then have
no guidance to the cutting system and the tine will be incised by the cutter.
Pos: 55.17 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
