Placing in Storage
337
Pos: 61.1 /Überschri ften/Überschri ften 1/A-E/Einlagerung @ 0\ mod_1197385459120_78. docx @ 19966 @ 11 @ 1
15 Placing in Storage
Pos: 61.2 /BA/Sic herheit/2. Vorangeste llte Warnhinweise/W ARNUNG - Nichtbeachtung der grundlegenden Sicherhei tshinweise alte Form @ 254\mod_1397485793575_ 78.docx @ 1953347 @ @ 1
WARNING!
If the basic safety instructions are not followed, people may be seriously injured or
killed.
• To avoid accidents, the basic safety instructions in the chapter Safety must have been
read and followed, see chapter Safety "Basic safety instructions".
Pos: 61.3 /BA/Sic herheit/2. Vorangeste llte Warnhinweise/W ARNUNG - Nichtbeachtung der Sicherheitsroutinen alte Form @ 273\mod_1 404117435996_78.d ocx @ 2058712 @ @ 1
WARNING!
If the safety routines are not adhered to, people may be seriously injured or killed.
• To avoid accidents, the safety routines in the chapter Safety must be read and followed,
see chapter Safety "Safety routines".
Pos: 61.4 /Überschri ften/Überschri ften 2/A-E/Am Ende der Ernte saison @ 0\mod_119738550127 6_78.docx @ 19985 @ 22 @ 1
15.1 At the End of the Harvest Season
Pos: 61.5 /BA/Einlager ung/Ladewagen/Ein lagerung allgemein @ 265\ mod_1400485978488_78. docx @ 2012854 @ @ 1
Before placing the machine in winter storage, clean it inside and outside thoroughly. To do this,
use a high-pressure cleaner. Do not hold the stream of water directly on the bearing points.
After cleaning is completed, lubricate all grease nipples. Do not wipe off any grease that comes
out of bearing points. The hardened grease will provide additional protection against moisture.
Check chains and sprocket wheels for wear. Oil and tighten cleaned chains.
Check all movable parts such as deflection rolls, joints, tensioning rolls, etc. to make certain
they move easily. If necessary, dismount, clean, grease and remount. If necessary, replace with
new parts.
Only use original KRONE spare parts.
Disassemble the universal shaft. Lubricate the inner tubes and the guard tubes with grease.
Grease the lubrication nipples on the universal joint and grease the bearing rings of the
protective tubes.
Park the machine in a dry location, but not in the vicinity of artificial fertilisers or livestock
buildings. Repair places with damaged paint and preserve all bare metal places thoroughly with
rust protection agent.
Caution!
The machine should only be placed on blocks with a suitable vehicle lifting device. Make
certain that the machine is stable and safe when it is on blocks.
To remove load from the tyres, set the machine on blocks. Protect the tyres against external
influences such as oil, grease and direct sunlight, etc.
Perform the necessary repair tasks during the time immediately after the harvest season. Draw
up a list of all spare parts you will need. This will make it easier for your KRONE dealer to
process your orders and you will be certain that your machine will be ready for use at the
beginning of the next season.
Pos: 61.6 /Layout Mo dule /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
