Start-up
85
Pos: 44.43 /BA/Inbetr iebnahme/Rundballe npresse/Netzbrem se @ 66\mod_130216722619 1_78.docx @ 614555 @ 22 @ 1
6.8 Net Brake
1
2
Fig. 51
• Before starting up for the first time, remove the sheet cleanly from the brake surface (1) of
the net brake disk (2)
Pos: 44.44 /Übersc hriften/Überschri ften 2/A-E/Einlaufzei t @ 66\mod_1302175770487_7 8.docx @ 615097 @ 22 @ 1
6.9 Running-in Period
Pos: 44.45 /BA/Inbetr iebnahme/Rundballe npresse/Einlauf zeit 100 Ballen @ 66\mod_130 2167892751_78.doc x @ 614617 @ @ 1
The time during which the first 100 round bales are formed may be considered the running-in
period. (i. e. until the colour on the bale chamber walls is ground off).
Note
The machine is designed for the specified bale diameters and firmness levels. Wrapping bales
of excess size or increased bale pressure too frequently will result in increased wear and may
result in premature damage to the machine (floor conveyor and drive).
Pos: 44.46 /BA/Inbetr iebnahme/Rundballe npresse/Ansprechen der Nockenschaltkup plung @ 66\mod_13021683 25377_78.docx @ 614645 @ 33 @ 1
6.9.1.1 Cam-type Clutch Engaging
If the cam-type clutch engages (slips through) during the baling process, proceed as follows:
• Turn off the PTO shaft
• Allow the PTO to run at idle until the cam-type clutch has engaged
• Allow the PTO to run at nominal speed
Pos: 44.47 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
