Settings
270
Pos: 57.7 /Überschri ften/Überschri ften 2/K-O/Netzbremse löse n @ 138\mod_135417947 9459_78.docx @ 1230660 @ 3 @ 1
12.1.1 Releasing the Net Brake
Pos: 57.8 /BA/Bedienung / Rundballenpresse/ Netz-Garnbindun g/Netzbremse lösen CF/ CV @ 137\mod_13535031673 68_78.docx @ 1218681 @ @ 1
b
Note
When the brake moves down into the feed position, it should be easy to release the brake to
remove the net.
COM00320
1
COM00013_1
4
5
8
6
X
7
Fig. 210
Note
If the tension of the spring (4) is stronger, the net is pulled more easily. However, when
starting, it pulls to the middle.
If the tension of the spring (4) is lower, pulling the net is more difficult. However, when starting,
the net remains further on the outside.
If the settings on the spring (1) are changed, the spring (4) must be adjusted accordingly:
• Move the net motor to the saved feed position (refer to “Menu 3-2 “Manual Operation of the
Baler” in the operation terminal).
• Install the locknut (5) flush with the end of the eye screw (6).
• Install the wire rope (7) with the wire rope clamps (8) without pressing together the springs
(4).
• Tighten the locknut (5) until the spring (4) is pressed together to a dimension of X = 130
mm.
Pos: 57.9 /Layout Mo dule /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
