Krone Comprima CF 155 XC - Adjusting the Gearbox on the Swivel Table

Operation
264
Pos: 55.168.48 /Übersc hriften/Übersc hriften 3/F-J/Getri ebe am Schwenktisch eins tellen @ 75\mod_13093381441 62_78.docx @ 662021 @ 3 @ 1
11.18.8 Adjusting the Gearbox on the Swivel table
Pos: 55.168.49 /BA/Bedi enung /Rundballenpr esse/Ballenwic kler/Getriebe am Schwenk tisch @ 75\mod_13093382 74310_78.docx @ 6620 45 @ @ 1
CPN00001_1
1
2
a
CPN00002_1
1
2
b
Fig. 205
Depending on which sheet roll size is used, the appropriate setting must be made on the
gearbox of the swivel table.
A label is located on the gearbox of the swivel table. This label shows the control settings of the
actuating lever (1) for the respective sheet roll size.
• Reverse the actuating lever (1) into the position shown on the label (2)
• Position (a) of the actuating lever (1) corresponds to the control setting for 750 sheet
• The position (b) of the actuating lever (1) corresponds to the control setting for 500
sheet
Pos: 55.169 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1