Operation
244
Pos: 55.134 /Übersc hriften/Überschr iften 3/A-E/E/E instellung der Bindepositio n (Prüfen) @ 55\mod_129 3087272540_78.doc x @ 526591 @ 33 @ 1
11.15.3 Setting of the Tying Position
Pos: 55.135 /BA/Bedienu ng /Rundballenpresse/ Netz-Garnbind ung/Bindeposition ei nstellen CF/CV @ 74\mod _1308833765916_78.doc x @ 658518 @ @ 1
3
1
2
RPN00045
Fig. 186
• Call menu “Manual Sensor Test” in the operation terminal.
• Initiate tying position by pressing the corresponding key.
• The engine automatically approaches the tying position.
Note
Once the engine has reached the tying position, the cable (1) must not be tight and the roller (2)
must be resting in front of the ratchet mechanism (3). If this is not the case, check the settings
of the cut-off position and the feed position and adjust, if necessary.
Pos: 55.136 /Übersc hriften/Überschr iften 3/A-E/A/A nzahl Netzumwicklungen @ 74\mod_ 1308834883068_78. docx @ 658546 @ 33 @ 1
11.15.4 Selecting the Number of Net Winds
Pos: 55.137 /BA/Bedienu ng /Rundballenpresse/ Netz-Garnbind ung/Netzumwicklunge n wählen CF/CV @ 200\mod_13854 51326263_78.do cx @ 1683055 @ @ 1
The number of net winds is set at the control.
KRONE ISOBUS-Terminal (comfort controls)
In Comfort electronics, the default bale size and the number of net winds are used to
automatically determine the net length.
Pos: 55.138 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1