Krone Comprima CF 155 XC - 11.10 Adjusting the baffle plate

Operation
226
Pos: 55.87.1 /Überschr iften/Überschr iften 2/P-T/Prallb lech verstellen @ 195\mod_1 383656418894_78.d ocx @ 1652771 @ 2 @ 1
11.10 Adjusting the baffle plate
Pos: 55.87.2 /Abkürzun gen /Abkürzungen spr achneutral/Rundba llenpressen/Compri ma CV 210 XC @ 140\mod_13553023 82014_0.docx @ 1248291 @ @ 1
Comprima CV 210 XC
Pos: 55.87.3 /BA/Bedi enung /Rundballenpres se/Prallblech verstellen/Prallb lech verstellen_Ein leitung @ 196\mod_13837515 49469_78.docx @ 1656355 @ @ 1
The height of the baffle plate (1) can be adjusted to the swath. Position I is the factory default
setting. If the crop is very moist, moving the baffle plate to position II is recommended.
Pos: 55.87.4 /BA/Bedi enung /Rundballenpres se/Prallblech verstellen/Prallb lech verstellen_Bil d Comprima, Ultima @ 229\mod_13 92892297796_78.doc x @ 1835805 @ @ 1
12
11
7
8
4
9
Fig. 165
Pos: 55.87.5 /BA/Bedi enung /Rundballenpres se/Prallblech verstellen/Prallb lech verstellen_Text Co mprima, Ultima @ 196\mod _1383752079844_78. docx @ 1656442 @ @ 1
Moving the baffle plate (1) from position I to position II
On the left and right side of the machine
• To remove the bracket (2),
• remove the linch pin (3).
• unscrew the round-head bolt (4).
• remove the spring (11).
• detach the bracket.
• Remove the linch pin (5).
• Move the baffle plate (1) to the upper bore and secure with the linch pin (5).
• To fit the bracket,
• insert the round head bolt (4) into the front square hole (6) and secure with a spacer
tube (7), washer (8) and locknut (9).
• place the bracket on the bolt (3) and secure with the linch pin (3).
• mount the spring (11).
Moving the baffle plate (1) from position II to position I
On the left and right side of the machine
• To remove the bracket (2),
• remove the linch pin (3).
• unscrew the round-head bolt (4).
• remove the spring (11).
• detach the bracket.
• Remove the linch pin (5).
• Move the baffle plate (1) to the lower bore and secure with the linch pin (5).
• To fit the bracket,
• insert the round head bolt (4) into the rear square hole (10) and secure with a spacer
tube (7), washer (8) and locknut (9).
• place the bracket on the bolt (3) and secure with the linch pin (3).
• mount the spring (11).
Pos: 55.88 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1