To this Document
11
Pos: 8 /Überschrif ten/Überschrif ten 1/U-Z/Zu diesem Dokument @ 107\ mod_1334231929021_78. docx @ 965257 @ 11 @ 1
3 To this Document
Pos: 9 /BA/Einleitun g/Gültigkeit/Rundb allenpressen/ Gültigkeit Comprima F/ V X-treme @ 307\mod_14163814 69758_78.docx @ 2382895 @ 2 @ 1
3.1 Validity
These operating instructions are valid for round balers of types:
Comprima F 155 XC X-treme Comprima V 150 XC X-treme
Pos: 10 /Überschrif ten/Überschrif ten 2/U-Z/Zielgruppe die ses Dokuments @ 187\mod_1380 113123454_78.doc x @ 1609723 @ 22 @ 1
3.2 Target group of this document
Pos: 11 /BA/Zu diesem Doku ment/Zielgruppe @ 188\ mod_1380114987653_78. docx @ 1610148 @ @ 1
This document is intended for the farmer and for other users who have no agricultural training
but who have been instructed in the use of the machine.
Pos: 12 /Überschrif ten/Überschrif ten 2/P-T/So benutzen Sie diese s Dokument @ 188\mod_138 0548350021_78.doc x @ 1614365 @ 22 @ 1
3.3 How to use this document
Pos: 13 /BA/Zu diesem Doku ment/So benutzen Sie diese An leitung @ 188\mod_13 80548527264_78.doc x @ 1614394 @ @ 1
Table of contents/headers:
The table of contents, as well as the headers in these instructions, are used for quick navigation
in the chapters.
Index:
You can use the index to find specific information on the required subject via keywords which
are in alphabetical order. The index is on the last page of these instructions.
Cross-references:
Cross-references to another place in the operating instructions or to another document are in
the text and specify the chapter and subchapter or section. The name of the subchapter or
section is in quotation marks.
Example:
Check that all screws on the machine are tight, see chapter Maintenance, "Tightening torques
for hexagonal head screws".
The subchapter or the section can be found via an entry in the table of contents and in the
index.
Pos: 15 /BA/Zu diesem Doku ment/Richtungs- und Ori entierungsangaben @ 188\ mod_1380609039179_ 78.docx @ 1615134 @ @ 1
Directional information in these operating instructions, such as front, rear, right and left, applies
in the direction of travel of the machine.
Orientation information concerning a diagram of a machine detail refers to the diagram itself and
is not relative to the direction of travel.
Pos: 16 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
