Krone Comprima CF 155 XC - Alarm Messages for Blade Comfort Selection

Operation of the Hydraulic Zero Setting of Blades (Optional)
207
Pos: 53.11 /BA/Inf o-Center/Rundballenpr esse/Hand-/Auto matikbetrieb/Alar mmeldungen bei Messernu llschaltung CCI @ 214\ mod_1390474160730_78. docx @ 1756784 @ 22 @ 1
10.1.1.2 Alarm messages for blade comfort selection
Notes and messages
No. Figure Possible cause Remedy
14
– Blade base is not closed.
– Close blade base using tractor
hydraulics.
– Check the setting of the "Blade
base monitoring" sensor.
32
– Blade preselection has been
changed
– Engage (activate) blade using
tractor hydraulics
33
– Blade preselection has been
changed.
– Disengage (deactivate) blade
using tractor hydraulics.
34
– Blade selection A sensors set
incorrectly.
– "Blade A on" and "Blade A
off" sensors have same
signal.
– Check the setting of the blade
selection A sensors.
35
– Blade selection B sensors set
incorrectly.
– "Blade B on" and "Blade B
off" sensors have same
signal.
– Check the setting of the blade
selection B sensors.
Physical messages
No. Symbol Sensor Possible cause Remedy
108 Blade base position
140 Blade B off
141 Blade B on
– Sensor or line
defective.
– Perform sensor
test.
– Check sensor and
line for damage.
142 Blade A off
143
Blade A on
Pos: 53.12 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1