Malfunctions - Causes and Remedies
346
Pos: 63.11 /Übersc hriften/Überschri ften 2/P-T/Störungen an der Wickeleinric htung @ 77\mod_1310046158285 _78.docx @ 667293 @ 22 @ 1
16.3 Malfunctions on the Wrapping Mechanism
Pos: 63.12 /BA/Störunge n - Ursachen und Behebung/ Rundballenpressen/ Tabellarische Auf listung Wickeleinr ichtung @ 77\mod_13100462 56731_78.docx @ 667325 @ @ 1
Malfunction Possible cause Remedy
Sheet blisters Brake force is too low
Check spring pretensioning on the
wrapping arm
Pre-stretch too high Change pre-stretch
Wrapping process does not
start
Signal wires on the swivel table
bent
Adjust signal wires
Sheet has been cut off to
early
Blades has been set too
aggressive
Set blades less aggressive
Sheet is not cutted Blade dull Grind blades
Tailgate does not close Shut-off valve closed Open the shut-off valve
Hydraulic oil gets too hot Filter blocked Replace the filter insert
Oil quantity too low Check oil level
Sheet tears Stretch rollers too rough Smooth stretch rollers with emery cloth
Additional brake too tight Adjust brake
Pos: 63.13 /Übersc hriften/Überschri ften 2/F-J/Fehlermeld ungen der KRONE Bedienter minals @ 77\mod_13100454 29649_78.docx @ 667242 @ 22 @ 1
16.4 Error Messages of KRONE Operation Terminal
Pos: 63.14 /BA/Störunge n - Ursachen und Behebung/ Rundballenpressen/ Fehlermeldungen werd en im Kapitel "KRONE IS OBUS-Terminal" beschr ieben. @ 232\mod_13935814880 10_78.docx @ 1853745 @ @ 1
The error messages in the display are described in the chapter “KRONE ISOBUS Terminal”.
Pos: 64 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
