ISOBUS operation
199
Pos: 51.8 /BA/Inf o-Center/Iso-Bedi enung/BigPack/Abweic hende Funktionen zum KRONE I SOBUS-Termina CCI @ 47\ mod_1285223499328_78.d ocx @ 455993 @ 22 @ 1
9.2 Differing functions to KRONE ISOBUS terminal CCI
Via the accessory unit, the ISOBUS control unit will provide information and control functions to
the display of the ISOBUS terminal. Operation with an ISOBUS terminal is analogue to the
KRONE ISOBUS terminal CCI. Prior to start-up, refer to the operating instructions for the
method of operation of the KRONE ISOBUS terminal CCI.
A fundamental difference to the KRONE ISOBUS terminal CCI is the arrangement of the
softkeys, which are determined by the selected ISOBUS terminal.
Only the functions that differ from the KRONE ISOBUS terminal CCI are described in the
following.
Pos: 51.9 /BA/Inf o-Center/Iso-Bedi enung/Rundballenpres sen/Abweichende Funkti onen CCI_Terminal_Ba llenfestigkeit @ 54\ mod_1290420016953_7 8.docx @ 509413 @ @ 1
Note
The values for “Bale size (Comprima
CV150)” and “Bale density (Comprima CF155)” which are
set by the scroll wheel in the basic screen on the KRONE ISOBUS terminal CCI, are set on the
ISO terminal with the selection key predetermined by the ISO terminal (refer to the operating
instructions of the ISO terminal manufacturer).
Pos: 51.10 /BA/Inf o-Center/Iso-Bedi enung/Abweichende Funkti onen CCI_Term Menüpunk t 1-4 „Kontrast“ @ 48\mod_128 6276672656_78.docx @ 4604 58 @ @ 1
Note
Menu item 1-4 "Contrast" of the KRONE control cannot be called up on the ISOBUS terminal. A
setting is performed directly via the ISOBUS terminal (if applicable) (refer to operating
instructions of the ISOBUS terminal manufacturer).
If necessary, acoustic signals must be enabled from the terminal (refer to operating instructions
of the ISOBUS terminal manufacturer).
Pos: 51.11 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
