Krone Comprima CF 155 XC - Alarm Messages; Acoustic Warnings

To Next Page

To Previous Page

KRONE ISOBUS Terminal

190

Pos: 48.225 /Übersc hriften/Überschr iften 3/A-E/A/A larmmeldungen @ 34\mod_125544 1373066_78.docx @ 323566 @ 33 @ 1

8.18.4 Alarm messages

Pos: 48.226 /BA/Inf o-Center/CCI-I SOBUS-Terminal/CCI- Rundballenpressen/ Hauptmenüs/Alarmmel dungen/Alarmmeldunge n allgemein @ 213\mod_13 90226364462_78.doc x @ 1750401 @ @ 1

F10

F11F11

F12

CC000240_1

Fig. 147

Alarm message

If a fault occurs on the machine, an alarm message appears in the display and an acoustic

signal sounds at the same time (continuous horn). Descriptions of the faults, their possible

causes and how to resolve them are described in the "Alarm messages" chapter.

Note

All functions in the menu that is covered over are still active. The softkeys that are covered by

the alarm message are disabled.

To reset the alarm:

• Briefly press the function button; the alarm is reset and the acoustic signal is stopped.

If the fault occurs again, the alarm message will appear again.

To delete an alarm:

• Hold down the button for the softkey for 5 seconds; the acoustic signal stops

immediately and the alarm is deleted.

If the fault occurs again, no alarm message will appear. The alarm message does not appear

when the fault occurs until after the control unit is turned off and back on.

Pos: 48.227 /Übersc hriften/Überschr iften 3/A-E/A/A kustische Hinweise @ 50\mod_128 7572164250_78.doc x @ 473885 @ 33 @ 1

8.18.5 Acoustic warnings

Pos: 48.228 /BA/Inf o-Center/CCI-I SOBUS-Terminal/CCI- Rundballenpressen/ Hauptmenüs/Alarmmel dungen/Akustische Hinweise @ 50\mod_1287572 618250_78.doc x @ 473966 @ @ 1

Wrapping is triggered

Filling reached, pre-signal reached,

wrapping complete, bale chamber closed

Continuous tone

Rapid interval

Medium interval

Long interval

Pos: 48.229 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1