Operation
220
Pos: 55.57 /Übersc hriften/Überschri ften 3/P-T/Rollboden spa nnen @ 192\mod_1382085134 347_78.docx @ 1637727 @ 33 @ 1
11.5.2 Tensioning the floor conveyor
Pos: 55.58 /Abkürzun gen /Abkürzungen sprac hneutral/Rundbal lenpressen/Compri ma CV 150 / CV 210 XC @ 199\mod_1384939505 399_0.docx @ 1676121 @ @ 1
Comprima CV 150 / CV 210 XC
Pos: 55.59 /BA/Bedienun g /Rundballenpresse/ Hinweise Rollboden sp annen @ 59\mod_129735 0006477_78.docx @ 55674 9 @ @ 1
Note
Clamp the floor conveyor of the bale chamber before the P.T.O. shaft is turned on.
Pos: 55.60 /BA/Bedienun g /Rundballenpresse/ Bild Handrad @ 105\ mod_1333020713111_78. docx @ 950800 @ @ 1
VPN00001_2
1
2
3
Fig. 159
Pos: 55.61 /BA/Bedienun g /Rundballenpresse/ Handrad eindrehen @ 59\ mod_1297350412235_ 78.docx @ 556776 @ @ 1
To do this:
• Screw in the handwheel (2) completely (working position)
Pos: 55.62 /BA/Bedienun g /Rundballenpresse/ Pressdruck ei nstellen @ 59\mod_12973510 58932_78.docx @ 556940 @ @ 1
After an extended standstill time of the machine and before it is started up for the first time:
• Open the tailgate and close it again once (see menu “Manual Operation Baler”, open/close
bale chamber)
• Turn on the PTO shaft
This will build up the baling pressure to the factory setting or the last pressure set.
The baling pressure can be changed with the turn dial (3) (see Chapter entitled “Baling pressure
setting”
Due to the hydraulically design of the accumulator connection block it can occur that the baling
pressure drops throughout a certain period of time. In order to reach the set baling pressure
again, open the tailgate once again and close it.
Pos: 55.63 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
